• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

As electricity became a common method of operating labour-saving appliances, a safe means of connection to the electric system other than using a light socket was needed. If you wish to charge your mobile with C Cable, all you need is a compatible charger using which you can plug your USB C cable. Farnsworth’s system captured moving images using a beam of electrons (basically, a primitive camera). However, this system was never converted into reality. However, what you take from them matters a lot. An electric boat trailer winch can help you reduce a lot of the work. While still more expensive than conventional propane style heaters, the Heat Wave can pay for itself in a short amount of time by not having to re-fuel every day. There are many fans including the best pedestal fans which could operate on a 24/7 basis for a complete summer where you may only pay less for the amount of electricity used.

Such stations may use similar on-air branding as that used by the nearby broadcast network affiliate, but the fact that these stations do not broadcast over the air and are not regulated by the FCC, their call signs are meaningless. They also require that all mains appliances for domestic use in the UK be supplied with approved BS 1363 plugs, but there is an exception for plugs fitted to shavers and toothbrushes which are normally a UK shaver plug (BS 4573) but may also be a Europlug (BS EN 50075). The regulations also contain a provision for the approval of non-BS 1363 conforming plugs when "the plugs are constructed using an alternative method of construction which provides an equivalent level of safety in respect of any risk of death or personal injury to plugs which conform to BS 1363 and is such that plugs of that type may reasonably be expected to be safe in use". Plugs and sockets for electrical appliances not hardwired to mains electricity originated in the United Kingdom in the 1870s and were initially two-pin designs. The plug has protruding pins (referred to as male) that fit into matching apertures (called female) in the sockets.

British Standards for plugs (with the exception of BS 4573) have always specified side entry flex (entry in other types is usually parallel to the axes of the pins). BS 546, Two-pole and earthing-pin plugs, socket-outlets and socket-outlet adaptors for AC (50-60 Hz) circuits up to 250 V is an older British Standard for three-pin AC power plugs and sockets. BS 546 plugs and sockets are still permitted in the UK, provided the socket has shutters. Distinctive characteristics of the system are shutters on the neutral and line (see § Concepts and terminology below) socket holes, and a fuse in the plug. In the United Kingdom and in Ireland, this system is usually referred to simply as a "13 amp plug" or a "13 amp socket". There is an erroneous tendency to refer to power conversion devices with incorporated plug pins as plugs, but IEC 60050 refers to these as 'direct plug-in equipment' defined as "equipment in which the mains plug forms an integral part of the equipment enclosure so that the equipment is supported by the mains socket-outlet". The brass pins appear relatively solid and large compared to others.

A plug is defined in IEC 60050 as an "accessory having pins designed to engage with the contacts of a socket-outlet, also incorporating means for the electrical connection and mechanical retention of flexible cables or cords". An adaptor (in the context of plugs and sockets) is defined in IEC 60050 as "a portable accessory constructed as an integral unit incorporating both a plug portion and one or more socket-outlet portions". EU countries each have their own regulations and national standards and CE marking is neither applicable nor permitted on plugs and sockets. Neutral is usually at or very near to earth potential, what is electric cable being earthed either at the substation or at the service entrance (neutral-to-earth bonding is not permitted in the distribution board/consumer unit). Line (commonly, but technically incorrectly, called live) carries the full supply voltage relative to the neutral. There is no European Union regulation of domestic mains plugs and sockets; the Low Voltage Directive specifically excludes domestic plugs and sockets. Modern British sockets for domestic use are normally manufactured as single or double units with an integral face plate and are designed to fit standard mounting boxes. British standards have proliferated throughout large parts of the former British Empire.